Mærker: Siva

RF400UF PVC ultra flex low loss

(0)
RF 400 UF - PVC - ultra flexible! med blød inderleder. HIGH PERFORMANCE BROADBAND LOW LOSS 50 OHM COAXIAL 100 meter ruller eller køb pr. meter. Diameter Ø 10,3 mm Pris pr. meter : 25 kr.  (vælg antal)   pr. 100m rulle : 2200 kr. 
Pris 20,00 kr.
Mere
På lager!

AirScatter server access - Donation

(0)
Donation : Server access with two redundant linesThis is only for use within AirScout software for hamradio operators competing in UKAC/NAC/IARU/DARC contests!Each and every of your donations counts ! Many thanks in advance for supporting ! 
Pris 113,09 kr.
Mere
På lager

Mærker: Prunus

Prunus J-369 Emg Radio AM/FM Solcelle/Håndsving

(0)
Nødradio AM/FM bærbar radio Solar håndsving USB, Indbygget 3000 mAh fast batteri. Der kan desuden monteres almindelige AA eller genopladelige LI-ION batterier. Genopladelig lommelygte læselampe SOS Alarm til nødsituationer.Du kan godt bestille på forhånd og være først i køen når næste sending kommer på lager. Det er en god ide at bestille til restordre så...
Pris 223,20 kr.
Mere
Kan sendes i dag (hverdage inden 16:00)

Mærker: Acta Berg

Acta Berg Crank Radio 5000 mAh Solar AM/FM/SW

(0)
Acta Berg Crank Radio Nødradio med håndsving og 5000 mAh batteri Solar Radio med World Receiver Håndsving Blackout nødudstyr som lommelygte & oplader AM/FM/SW med USB tilslutning, Grå Du kan godt bestille på forhånd og være først i køen når næste sending kommer på lager. Det er en god ide at bestille til restordre så du er sikker på at få en.Læg i...
Pris 479,20 kr.
Mere
Kan sendes i dag (hverdage inden 16:00)
Alle bedst sælgende
SSB DCW 2004 B Sequencer
  • SSB DCW 2004 B Sequencer

SSB DCW 2004 B Sequencer

The Bias-T incl. Sequencer, DCW 2004 B, allows a comfortable remote coupling of our
MHP - R and SUPER - AMP preamplifiers via the coaxial cable as well as for delayed
switching of HF-linear amplifiers.
1.879,20 kr.
Leveret indenfor 5-7 dage
Antal
Kan bestilles

Beskrivelse
The Bias-T incl. Sequencer, DCW 2004 B, allows a comfortable remote coupling of our
MHP - R and SUPER - AMP preamplifiers via the coaxial cable as well as for delayed
switching of HF-linear amplifiers.
 
The sequential operation of the DCW 2004 B avoids reliably damage to the preamlifier
that may be caused by HF-spikes during switching. It offers 3 switching outputs in total,
which have ascending delay times. So not only linear amplifiers but other devices, like
transverters, can be switched on with defined times.
 
The DCW 2004 B is designed for the amplifiers MHP - R and SP series. The PTT switching
input of the DCW 2004 B accepts a circuit against ground or against + 5 ... 12 V.
The preamlifier and a linear amplifier (if used) can be switched on or off as required.
 
The HF-section of the DCW 2004 B offers a very low inseration loss and a high shielding
factor.
 
 
 
Technical Data* DCW 2004 B 6m, 2m, 70cm 23cm DCW 2004 B SHF 13cm, 23cm
Transmissible power 6 m / 1,0 kW CW
/ 2,0 kW PEP
2 m / 1,0 kW CW
/ 2,0 kW PEP
70 cm / 0,6kW CW
/ 1,2 kW PEP
23 cm / 0,3kW CW
/ 0,6 kW PEP
23cm = 150 W
13cm = 100 W
Insertion loss
0,1 dB
0,2 dB
Connection norm
N-Socket
Preamplifier voltage
(remote feeding)
0,5 A max loadable
PTT switching output
power amplifier
30 V at 0,5 A max.
Relay switching outputs
30 V at 0,5 A max.
-PTT Input
switches at
+PTT Input
switches at >5 V
Operating voltage
12-14 V
Recommended voltage
13,8 V
Dimensions
40x120x654 mm
Weight
600 g

*only applicable to equipment in 2015

The PTT control of the transceiver must take place in analogue operating modes (SSB, CW FM) from connection 6 of the DCW 2004 B sequencer. You must then control the PTT with a foot switch. Or you have to cut the PTT line on the microphone. When using the WSJT-X program, the PTT output socket of the transceiver must be connected to connection 3 of the DCW 2004 B sequencer. Set the TX delay to 0.5 sec in the program under Settings → Advanced!

The following diagrams show how to connect the DCW 2004 B:

For CW/SSB/FM:


 














































 

For WSJT-X:



















Produktoplysninger/Status
Anmeldelser (0)
Bedømmelse
Der er ingen kundeanmeldelser endnu.
5 andre varer i den samme kategori:

Mærker: Antennas-Amplifiers

2m Bias Tee 1500W 144 – 148 MHz

(0)
What’s a Bias Tee? A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable. The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed. A bias tee is a passive...
Pris 718,40 kr.
Mere
På lager

Mærker: Antennas-Amplifiers

1296MHz 23cm 600 W Bias Tee

(0)
What’s a Bias Tee? A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable. The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed. A bias tee is a passive...
Pris 718,40 kr.
Mere
På lager

Mærker: Antennas-Amplifiers

Bias-T guide og diagrammer

(0)
What’s a Bias Tee? A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable. The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed. A bias tee is a passive...
Mere
På lager

Mærker: Antennas-Amplifiers

2m/70cm combi Bias Tee 1500W/1200W

(0)
What’s a Bias Tee?A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.A bias tee is a passive RF...
Pris 718,40 kr.
Mere
På lager

Mærker: Antennas-Amplifiers

432MHz 70cm 1200 W Bias Tee

(0)
What’s a Bias Tee?A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.A bias tee is a passive RF...
Pris 718,40 kr.
Mere
På lager

Følg os på Facebook