- Radios
- Antennas
- Baluns/Antenna parts
- Hamradio
- Power Amplifiers
- CB Radio
- Prepping
- Scannere
- DVNoder/ADSB/Meshtastic/Arduino/PI
- Marine
- Autotilbehør
- Radio Sonde
- Components
- Gift voucher
- Backuppower/Inverters/Reducers
- DECT intercom
Brand: Siva
RG 213 U /MIL-C-17F - 1m
RG 213 U /MIL-C-17F standard.
50 OHM RF COAXIAL CABLE Class CPR Eca
MANUFACTURED IN COMPLIANCE WITH MIL-C-17F STANDARDS
100 meter rolls or purchase per meters. Diameter Ø 10,3 mm
Brand: Siva
RF400UF PVC ultra flex low loss
RF400UF-PVC - ultra flexible! with soft inner conductor for mounting in the mast etc.
HIGH PERFORMANCE BROADBAND LOW LOSS 50 OHM COAXIAL
100 meter rolls or purchase per meters. Diameter Ø 10.3 mm
Brand: Prunus
PRUNUS J-924D 10000mAh Solar DAB+/FM/SD/BT/USB+AAA
PRUNUS J-924D 10000mAh håndsvingsradio, nødradio Solar, DAB og DAB+ FM AAA batteridrevet radio, USB-opladning, fakkel og læselys, SOS Alarm, Power Bank, Kompas til campingBluetooth, SD/TF kort afspilning.Super lækker radio der har det hele.
Brand: Import Solar Radioer
12000maH, AM/FM bærbar USB radio
12000mAh solradio, håndsving radio, bærbar nødradio Dynamo-radio med AM/FM, med genopladelig powerbank, LED-læselampe, kompas, SOS-alarm til camping dør nødsituation
Brand: Prunus
Prunus J-369 Emg Radio AM/FM Solar/Hand Crank
Emergency Radio AM/FM Portable Radio Solar Hand Crank USB AA Batteries Rechargeable Torch Reading Lamp SOS Alarm for Emergencies
2m Bias Tee 1500W 144 – 148 MHz
What’s a Bias Tee?
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit consisting of capacitors and inductors. Act as a diplexer by combining DC and RF signals onto a common port RF+DC.
Description
Antennas-Amplifiers “2m Bias Tee” has impressive RF performance on 2m 144-148 MHz and full power handling 1500W.
Best-in-class electrical performance:
Frequency Range: 144 – 148 MHz
Maximum Power at SWR 1:1 1500W
Insertion loss: 0.015dB
Input Return Loss: -40dB
Isolation RF port to DC port: 100dB
DC resistance from DC to RF: 0.15 Ω
Supply Voltage: 30V
Supply Current: 1A
Connectors “N”
Permanent damage may occur if any of these limits are exceeded.
Measured extremely high DC-RF isolation 100 dB that minimizes RF signal leakage and interference with other devices.
2 m Bias Tee 144 – 148MHz Full Power 1500 W Measured Super Low Loss Insertion Loss and ultimate Return Loss
Usually positioned at the end of the coaxial cable to pass DC power to the remote device.
Inject DC into Coaxial cable.
Extracts DC from Coaxial cable.
144-148MHz 2m 1500W Ultimate Bias Tee Outdoor Mounting
Product Details
Comments (0)
Grade
No customer reviews for the moment.
5 other products in the same category:
Brand: Antennas-Amplifiers
1296MHz 23cm 600 W Bias Tee
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit...
Brand: Antennas-Amplifiers
432MHz 70cm 1200 W Bias Tee
What’s a Bias Tee?A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.A bias tee is a passive RF...
Brand: Antennas-Amplifiers
Bias-T guide and diagrams
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit...
Brand: Antennas-Amplifiers
2m Bias Tee 1500W 144 – 148 MHz
What’s a Bias Tee?A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.A bias tee is a passive RF...
Brand: SSB-Electronic
SSB DCW 2004 B Sequencer
The Bias-T incl. Sequencer, DCW 2004 B, allows a comfortable remote coupling of our
MHP - R and SUPER - AMP preamplifiers via the coaxial cable as well as for delayed
switching of HF-linear amplifiers.
You might also like
What’s a Bias Tee?
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit consisting of capacitors and inductors. Act as a diplexer by combining DC and RF signals onto a common port RF+DC.