Brand: Siva
Brand: Prunus
Brand: Acta Berg
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit consisting of capacitors and inductors. Act as a diplexer by combining DC and RF signals onto a common port RF+DC.
Frequency Range: 400 – 500 MHz
Maximum Power at SWR 1:1 1200W
Insertion loss: 0.01dB
Input Return Loss: -35 dB
Isolation RF port to DC port: 80 dB
DC resistance from DC to RF: 0.15 Ω
Supply Voltage: 30V
Supply Current: 1A
Connectors “N”
Permanent damage may occur if any of these limits are exceeded.
70 cm 1200 W Ultimate High Power Bias-Tee 430-450 MHz Measured extreme high DC-RF isolation 80 dB that minimizes RF signal leakage and interference with other devices.
70 cm Bias Tee 430 – 450 MHz High Power 1200 W Measured Super Low Loss Insertion Loss and excellent Return Loss
The recommended position of 70 cm outdoor Bias-Tee is at the end of the coaxial cable to pass DC power to the remote device.
Inject DC into Coaxial cable.
Extracts DC from Coaxial cable.
400 -500 MHz 70 cm 1200 W Ultimate Bias Tee Outdoor Mounting appearance
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Brand: Antennas-Amplifiers
Brand: Antennas-Amplifiers
Brand: Antennas-Amplifiers
Brand: Antennas-Amplifiers
Brand: SSB-Electronic
A “Bias-Tee” also known as a “DC Inserter” is a simple way to feed DC power through coaxial cable to the remote device such as a pre-amplifier and – or transmit/receive relays via the coaxial cable.
The main task is to inject DC into or extract DC current from the coaxial cable, leaving the RF signal undisturbed.
A bias tee is a passive RF circuit consisting of capacitors and inductors. Act as a diplexer by combining DC and RF signals onto a common port RF+DC.
check_circle
check_circle
